Maintenance Kit, Becker, VTLF, VTLF 400, VTLF 500, Part# 338051M0000

This is a complete tune-up kit for your Becker VTLF pump. It comes in one box. Inside, you will find every part you need for a full service :

• A Filter Cartridge to clean the air going into your pump

• A Vane Kit with new vanes to replace the worn ones

• Two tubes of special grease to keep the bearings running smooth

No running around. No multiple orders. Just one box with everything inside.

This kit is made for two specific Becker pump models :

• VTLF 400

• VTLF 500

If you have one of these pumps, this kit is the right choice for your next service.

Part 1: Filter Cartridge (90954000000)

This is the air filter for your pump . It cleans the air before it enters the pump. A dirty filter lets dust and dirt inside. That dirt grinds down your vanes and cylinder.

This filter cartridge is made specifically for dry-running Becker pumps. It keeps the bad stuff out and lets clean air in .

Part 2: Vane Kit (90137301010)

The vanes are the parts that actually move the air inside your pump. They slide back and forth thousands of times per minute. Over time, they wear down.

When vanes wear, your pump loses vacuum. It gets slower. It works harder.

This vane kit gives you a complete set of new vanes for your pump . Put them in, and your pump pulls like new again.

Part 3: TA15/2 Grease (74330500000P)

Your pump has bearings that spin at high speed. Those bearings need grease. Not any grease. Special grease.

This is Amblygon TA 15/2 grease . It is the grease Becker recommends for their VTLF pumps. It handles high heat. It stays in place. It does not break down.

You get two 50g tubes in this kit . That is enough for a full bearing service on both sides of your pump