$67.20
Keep your DVP dry vacuum pump running strong. This high-quality replacement vane fits multiple pump models including CB 100, CC 100, SB 100, SC 100, CB 140, CC 140, SB 140, and SC 140. If your pump is losing suction, a worn vane is often the cause. Swap in this new vane and get your equipment back to full power.
Vane, DVP, Dry Vane, CB/CC/SB/SC 100/140, Part# 3301021
Vane, DVP, Dry Vane, CB/CC/SB/SC 100/140, Part# 3301021
Vanes are small parts inside your dry vacuum pump. They spin around at high speed. This spinning creates the suction your work depends on.
But vanes wear down over time. They get smaller. The edges get rounded.
When that happens, your pump cannot work right. It loses efficiency. It struggles to pull good vacuum.
The fix is simple. Take out the old worn vane. Put in a fresh one.
This vane is made to exact standards. It comes from Italy, where they are known for quality manufacturing.
The material is high-grade carbon. It lasts a long time. It handles heat well. It keeps its shape so your pump works properly .
When you use a good quality vane, your pump runs smoother. It makes less noise. It gives you the strong, steady suction you need.
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
DVP LC.20 pump sealed tight. This Case Gasket (Part # 4901072) goes between the pump body and the end cover. Replace it every time you open the pump for service. It stops air leaks and keeps your vacuum strong.
Keep your DVP LC 105 vacuum pump running clean with this gas ballast filter. This filter cleans the air that enters your pump through the gas ballast valve. A clean gas ballast system helps remove water vapor and condensable gases from your pump oil. OEM quality direct replacement.
Keep your DVP LC 25 vacuum pump running clean with this air-oil separator / exhaust filter. This filter removes oil mist from the exhaust air before it leaves your pump. Without a good separator, oil vapor escapes into your workspace. Designed and manufactured by DVP for a perfect fit .
10 in stock
Replace the worn coupling spider in your DVP vacuum pump with this Rotex 28 spider element. Made for DVP LC 105 pumps. This flexible polyurethane spider connects the motor shaft to the pump shaft. It transmits power while absorbing shocks and compensating for minor misalignment. A small part that keeps your pump running smoothly.
Keep your DVP vacuum pump running clean with this air intake filter. This filter stops dust, dirt, and other airborne particles from entering your pump. Clean air means longer pump life and better performance. Designed and manufactured by DVP for a perfect fit.
Keep your DVP lubricated vane pump running smoothly with this oil filter. Made specifically for DVP LB40, LB60, LB100, and LC series pumps . This filter removes dirt, debris, and other contaminants from your pump oil. Clean oil means longer pump life and better performance. OEM quality direct replacement.
Keep your DVP LC150 vacuum pump running clean with this
This is an exhaust filter / air-oil separator (Part # 1801063). It is designed and manufactured by DVP for use in the LC150 vacuum pump .
This filter sits inside your pump’s exhaust system. Its job is to catch tiny oil droplets before they leave the pump. Clean air goes out. The oil stays inside where it belongs.
air-oil separator / exhaust filter. This filter removes oil mist from the exhaust air before it leaves your pump. Without a good separator, oil vapor escapes into your workspace. Designed and manufactured by DVP for a perfect fit
Keep your DVP dry vane vacuum pump running clean with this air intake filter. Made specifically for DVP SB 40 and SC 40 dry-running vane pumps . This filter stops dust, dirt, and other particles from entering your pump. Clean air means longer pump life and better performance. OEM quality direct replacement.
20 in stock
Keep your DVP vacuum pump running clean with this air intake filter. This filter stops dust, dirt, and other airborne particles from entering your pump. Clean air means longer pump life and better performance. Designed and manufactured by DVP for a perfect fit.
Keep your DVP vacuum pump running clean with this exhaust filter / air-oil separator. Made for DVP LB 18 and LB 25 lubricated vane pumps. This filter removes oil mist from the exhaust air before it leaves your pump. Without a good separator, oil vapor escapes into your workspace. OEM quality direct replacement.
Not a member? Create an account
Already got an account? Sign in here
Reviews
There are no reviews yet.