$10.22
Replace the worn shaft seal on your small Edwards pump with this Viton part. Part number 02109079 (also listed as SB0088) fits the E2M0.7, E2M1, and E2M1.5 models. This is a metal-cased Viton seal with dimensions of 16mm x 30mm x 7mm . It handles heat and chemicals better than standard rubber.
Shaft Seal, Edwards, E1/E2M, Part# 2109079
Shaft Seal, Edwards, E1/E2M, Part# 2109079
This is a shaft seal for Edwards E2M0.7, E2M1, and E2M1.5 pumps. The part number is 02109079 .
A shaft seal sits where the spinning shaft goes into the pump body. It keeps oil inside the pump. It keeps dirt and air outside.
This seal has specific dimensions: 16mm inner diameter, 30mm outer diameter, and 7mm width . It has a metal case with a Viton rubber sealing lip .
When this seal fails, you will see oil leaking from your pump. Your pump will lose vacuum power. It will run hotter than normal.
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
Out of stock
The Mesh Inlet Strainer (Part # 22305056) is a replacement part for the smallest Edwards E1/E2M series rotary vane pumps. It fits specifically the E2M0.7, E2M1, and E2M1.5 models . This is a simple metal mesh screen that sits inside the inlet port.
Out of stock
Out of stock
10 in stock
Out of stock
10 in stock
Out of stock
10 in stock
The Spring, Edwards, E1/E2M (Part #27102034) is a direct replacement spring for Edwards small vacuum pumps. It fits E2M0.7, E2M1, and E2M1.5 models . These are compact, single-phase rotary vane pumps often used in laboratories. This spring is an essential mechanical component inside the pump . If you are rebuilding your pump, this spring should be replaced as part of a major overhaul.
10 in stock
Out of stock
Not a member? Create an account
Already got an account? Sign in here
Reviews
There are no reviews yet.