$10.22
Replace the worn shaft seal on your small Edwards pump with this Viton part. Part number 02109079 (also listed as SB0088) fits the E2M0.7, E2M1, and E2M1.5 models. This is a metal-cased Viton seal with dimensions of 16mm x 30mm x 7mm . It handles heat and chemicals better than standard rubber.
Shaft Seal, Edwards, E1/E2M, Part# 2109079
Shaft Seal, Edwards, E1/E2M, Part# 2109079
This is a shaft seal for Edwards E2M0.7, E2M1, and E2M1.5 pumps. The part number is 02109079 .
A shaft seal sits where the spinning shaft goes into the pump body. It keeps oil inside the pump. It keeps dirt and air outside.
This seal has specific dimensions: 16mm inner diameter, 30mm outer diameter, and 7mm width . It has a metal case with a Viton rubber sealing lip .
When this seal fails, you will see oil leaking from your pump. Your pump will lose vacuum power. It will run hotter than normal.
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
10 in stock
Out of stock
Out of stock
The Spring, Edwards, E1/E2M (Part #27102034) is a direct replacement spring for Edwards small vacuum pumps. It fits E2M0.7, E2M1, and E2M1.5 models . These are compact, single-phase rotary vane pumps often used in laboratories. This spring is an essential mechanical component inside the pump . If you are rebuilding your pump, this spring should be replaced as part of a major overhaul.
Out of stock
10 in stock
10 in stock
The Mesh Inlet Strainer (Part # 22305056) is a replacement part for the smallest Edwards E1/E2M series rotary vane pumps. It fits specifically the E2M0.7, E2M1, and E2M1.5 models . This is a simple metal mesh screen that sits inside the inlet port.
Out of stock
Out of stock
Out of stock
10 in stock
Not a member? Create an account
Already got an account? Sign in here
Reviews
There are no reviews yet.