$265.60
The Edwards EMF3 Oil Mist Filter (Part # 46220000) is a exhaust filter for smaller Edwards rotary vane vacuum pumps . It captures oil mist before it can escape into your workspace. This keeps your air clean and helps you follow health and safety rules . The filter has two stages. First, it traps oil droplets. Then it uses activated carbon to remove bad smells . It fits E2M0.7, E2M1.5, and Speedivac 2 pumps right out of the box .
Edwards Mist Filter, Part# 46220000
Edwards Mist Filter, Part# 46220000
Think of it as a two-step cleaning system .
Step 1 – Catching the oil. The exhaust gas enters the filter and passes through a special glass fiber element . This element acts like a very fine net. It catches tiny oil droplets. The oil then drips down and collects in the bottom of the filter. You can see how full it is through the semi-transparent white bottom half of the filter body . When it gets full, you just open the drain plug.
Step 2 – Killing the smell. After the air passes through the oil filter, it goes through an activated carbon odor element . This absorbs any remaining oil vapor and odors. So the air that finally leaves the filter is clean and smells like nothing .
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
|
|
|
0% |
The COUPLING BOSS is a replacement part made for Edwards EH Series Mechanical Booster Pumps. It is an important part of the hydrokinetic coupling assembly. This assembly connects the motor to the pumping mechanism. The coupling boss helps transmit power smoothly from the motor to the pump rotors. If this part wears out, your pump may not run correctly. Replace it to keep your pump working like new.
This is a inner ring for needle roller bearings used in Edwards vacuum pumps and boosters. It features a 30mm inner diameter, a 35mm outer diameter, and is 18mm wide .
10 in stock
The COUPLING COVER EH250/500 C/SEAL PK 1 is a complete replacement cover for the Edwards EH250 and EH500 mechanical booster pumps. It comes with the seal already included. This cover bolts onto the side of the pump where the motor connects. It protects the coupling area and holds the oil inside. If your existing cover is cracked, leaking oil, or damaged, this is the direct replacement you need. It fits both the EH250 and EH500 pump models .
10 in stock
10 in stock
10 in stock
The COUPLING BOSS FOR E2M28 PK1 is a replacement part made for the Edwards E2M28 rotary vane vacuum pump. This small metal part is a key piece of the drive coupling assembly. It connects the motor shaft to the pump shaft. Without a good coupling boss, the motor cannot turn the pump. If your pump is not pulling vacuum or making strange noises, this part may be worn out. Replace it to get your pump running again.
This is a cylindrical roller bearing for Edwards E1M80 and E2M80 vacuum pumps.
The COUPLING ELEMENT EM18/28/30 is a rubber replacement part for Edwards rotary vane vacuum pumps. It is also called a spider. This small rubber piece sits between the motor coupling and the pump coupling. Its job is to transfer power from the motor to the pump while absorbing vibration and shock. If your pump is noisy or vibrating too much, this part may be worn out. Replace it to make your pump run smooth and quiet again
10 in stock
This Coupling Baffle is a replacement part designed for the coupling cover assembly. It helps control oil flow and stops excess mist from escaping the gearbox.
Not a member? Create an account
Already got an account? Sign in here
Reviews
There are no reviews yet.